Pre-Installation And Application Warnings - Directed DB3 Installation Manual

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Key2GO is required if only one master key is available. You can program the interface without the need for Key2GO if
Š
two master keys are present.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
Š
connector.
Refer to the "Vehicle connections" following the installation diagram.
Š
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin.
[2]
If present, CAN connections are ONLY required is using in conjunction with SmartStart.
[3]
Warning: To avoid vehicle damage, refer to 'Vehicle connections' for parking light and Configuration.
[4]
5
403.FORD1 4.21 2005 Lincoln LS
© 2020-06-02 Directed. All rights reserved.
Keys required for
1 or 2
programming
Keys required for
0
operation