Table of Contents
Advertisement
6.
When a standpipe is being used it must be as wide as possible; i.e. the pipe diameter must be at least half its
height, preferably made of plastic. The base MUST have a 45° chamfer to reduce the echo size from the bottom of the
standpipe. No welding should be present on the inside of the pipe as this causes false echoes.
7.
If any large electrical equipment is installed in the vicinity, then earthed steel conduit must be used.
7.0
KEY DESCRIPTION
KSONIK MICRO is "user friendly" having only 5 keys and a menu driven display. The keys are listed below with their
appropriate functions.
SCROLL
This is used to initially access the programming and then to run through the various menus.
This key is used to INCREASE the value in the various commands. This key also starts the simulation
▼
This key is used to INCREASE the value in the various commands. This key also starts the simulation
mode decreasing in level. See page 48 for details.
When a value has been changed it is only accepted by pressing the ENTER key. The ENTER key while
ENTER
in run mode scrolls through the relay status screen and onscreen KScope screen.
See page 32 for details.
RUN
When programming is complete, press RUN to return KSONIK MICRO back to the run mode.
7.1
Security Code
To advance to the programming mode the correct security code must be entered. The factory default code is 5159. This
code can be changed in the programming mode. If you forget the security code please contact your local ABB agent for
the override code.
8 KSONIK MICRO Ultrasonic Level Transmitter | Operation instruction manual
mode increasing in level. See page 48 for details.
Advertisement
Table of Contents
