Mase Generators IS 10 T Use And Maintenance Manual page 47

The generator was designed, constructed and tested to meet the current European and national regulations and
to reduce the electrical risks to a minimum in compliance with the following regulations:
2.1 Reference documents
The instructions for use provided with each generator are made up of a set of documents of which this manual
represents the General Part. Normally, the following documents are provided.
a CE Declaration of Conformity.
b Instruction manual for use and maintenance of the generators (this manual).
c Engine use and maintenance manual.
d Alternator use and maintenance manual (in case of alternators not manufactured by Mase).
e List of Mase Service Centres.
f Mase Warranty certificate.
g Warranty card.
2.2 Facsimile of CE declaration of conformity
The generators constructed by Mase, intended for countries in the European Community, are in conformity with
the applicable EEC Directives and are furnished with an EC Declaration of Conformity (Fig.B).
2.3 Marking
The generator identification plate carries all the identification data in conformity in accordance with the provisions
for CE Marking for those cases where required. Below is a facsimile of the identification plate fixed on the con-
trol panel of each generator (Fig. A).
1 - Machine name
2 - Machine code
3 - Serial number
4 - Rated power
5 - Declared frequency
6 - Rated power factor
7 - Rated voltage
8 - Rated current
9 - Degree of protection
10 - Class of isolation
11 - Temperature max. of use
12 - Altitude max. of use
13 - Noise level
14 - Performance class
15 - Year of construction
16 - Manufacturer - Adress
17 - Weight
2 GENERAL INFORMATION
EEC 73/23 directive: low voltage
EEC 89/392 machine directive
1
2
4
5
6
7
8
9
10
11
12
13
14
15
IS 10 T
50 Hz
GB
3
16
17
Fig.A
GB
- 13