Standby Led: Setting The Front Panel Led Behaviour; Auto On: Setting The Young Mkiv Behaviour When Power Is Applied; Remote On/Off: Setting The Young Mkiv To Accept/Ignore The Ir Remote On/Off Command - M2TECH YOUNG MKIV User Manual

YOUNG M IV
K
DIGITAL-TO-ANALOG CONVERTER AND PREAMPLIFIER
REVISION PrA – DECEMBER 2020

7.5.16. STANDBY LED: Setting the Front Panel LED behaviour

The front panel LED of the YOUNG MKIV (Fig. 1, 2) can be set to operate in three different
modes, at user's convenience:
 ON: the LED will be continuously blowing when the YOUNG MKIV is in standby
 FLASHING: the LED will blink when the YOUNG MKIV is in standby
 OFF: the LED will be off when the YOUNG MKIV is in standby
STANDBY LED
ON

7.5.17. AUTO ON: Setting the YOUNG MKIV Behaviour when power is applied

The YOUNG MKIV may have different behaviours when power is applied to its power socket
(Fig. 2, 18).
User may choose to have the Young MkIV immediately on and operative or wait for the
front panel button (Fig. 1, 6) to be pressed.
When the YOUNG MKIV is used standalone with its stock wall adaptor, the latter is the
preferred choice. On the other hand, when the YOUNG MKIV is used with the VAN DER GRAAF
M II or any other power supply which is slave to a global activation control or trigger,
K
having the YOUNG MKIV immediately on after applying power is the best choice.
The YOUNG MKIV behaviour is set by jointly operating the rear panel power mode switch
(Fig 2, 11) and this menu feature. For more details, please see Chapter 7.7.
7.5.18. REMOTE ON/OFF: Setting the YOUNG MKIV to Accept/Ignore the IR
Remote ON/OFF command
When the YOUNG MKIV is used together with the VAN DER GRAAF M
feature is enabled, it may be desirable to inhibit the on/off command from the IR remote
SETUP
STANDBY LED
STANDBY LED
FLASHING
SETUP
POWER MODE
POWER MODE
NORMAL
POWER MODE
AUTO ON
29
M2Tech
www.m2tech.biz
STANDBY LED
OFF
II and the auto-on
K
Copyright © 2017, M2Tech Srl