Remote Control - M2TECH YOUNG MKIV User Manual

YOUNG M IV
K
DIGITAL-TO-ANALOG CONVERTER AND PREAMPLIFIER
REVISION PrA – DECEMBER 2020

4. Remote Control

Figure 3
The YOUNG MKIV comes with a fully-loaded remote control which
allows for setting all of its controls, as well as for controlling other
M2Tech Rockstars series products.
Please note when a command is sent to the YOUNG MKIV the
"DAC" key blinks in green. If any of the other key "AMP",
"PHONO" or "PLAYER" blinks instead, the YOUNG MKIV will not
receive the command. In this case, press the "DAC" key to select
the right commands codes for the YOUNG MKIV.
Below is a brief description of the relevant keys for the YOUNG
MKIV.
Standby key: This allows for putting the YOUNG MKIV in standby
mode (prolonged push) and for awakening it.
DIM: Display dimming.
DAC: Instructs the remote to send commands using the DAC
system code.
PHASE: Analogue output phase toggle.
MENU: Configuration menu access.
ESC: Menu exit with changes discarded.
Cursor keys: Allow for menu navigation.
OK: Menu exit with changes stored.
VOL+/VOL-: Volume setting.
MUTE: Mute toggle on/off.
IN+/IN-: Input selection.
Player Controls: these buttons are dedicated to the control of an
audio player running on the computer attached to the YOUNG
MKIV. The following commands can be sent: Play/pause, stop,
next, track, previous track
14
M2Tech
www.m2tech.biz
Copyright © 2017, M2Tech Srl