Remote Control - M2TECH YOUNG MKIII User Manual

YOUNG M III
K
DIGITAL-TO-ANALOG CONVERTER AND PREAMPLIFIER
REVISION 1.0 – SEPTEMBER 2017

4. Remote Control

Figure 3
The YOUNG MKIII comes with a fully-loaded remote control which
allows for setting all of its controls, as well as for controlling other
M2Tech Rockstars series products.
Please note when a command is sent to the YOUNG MKIII the
"DAC" key blinks in green. If any of the other key "AMP",
"PHONO" or "PLAYER" blinks instead, the YOUNG MKIII will not
receive the command. In this case, press the "DAC" key to select
the right commands codes for the YOUNG MKIII.
Below is a brief description of the relevant keys for the YOUNG
M III.
K
Standby key: This allows for putting the YOUNG M
mode (prolonged push) and for awakening it.
DIM: Display dimming.
DAC: Instructs the remote to send commands using the DAC
system code.
PHASE: Analogue output phase toggle.
MENU: Configuration menu access.
ESC: Menu exit with changes discarded.
Cursor keys: Allow for menu navigation.
OK: Menu exit with changes stored.
VOL+/VOL-: Volume setting.
MUTE: Mute toggle on/off.
IN+/IN-: Input selection.
Player Controls: these buttons are dedicated to the control of an
audio player running on the computer attached to the YOUNG
MKIII. The following commands can be sent: Play/pause, stop,
next, track, previous track
13
M2Tech
www.m2tech.biz
III in standby
K
Copyright © 2017, M2Tech Srl