Connecting And Installing The Duofern 1-10V Controller - RADEMACHER DuoFern 9482 Instruction Manual

8.3 Connecting and installing the
i
DuoFern 1-10V Controller
1.
Ensure the mains are current-free and check whether the inlet
leads are current-free.
2.
Securely lay the connecting cables in the flush-mounted box of
the DuoFern 1-10V Controller.
3.
Remove the insulation on all leads as specified above and con-
nect them according to the following connection diagram.
4.
Insert the DuoFern 1-10V Controller into the flush-mounted box
and lay the connecting cables as well as the antenna in the box.
5.
Finally, install the cover of the flush-mounted box and switch on
the electricity again.
EN
27