Table of Contents
Advertisement
8.1 Safety instructions for the electrical
i
connection
There is a risk of fatal injury caused by short circuiting
when the DuoFern 1-10V Controller is overloaded.
◆ The maximum load of the 1-10V interface is 60 mA.
◆ Please refer to the respective operating manual for the
ballast load.
230 V / 50 Hz output / load contact [ L' ]:
◆ The maximum switching capacity must not be exceeded.
Please observe the details in the technical specifications,
see page 22.
Connecting the 1-10V control lead with the incorrect polari-
ty can destroy the device.
◆ Pay attention to the correct polarity when connecting the
1-10V control lead.
A defective antenna can cause malfunctions or the failure of
the DuoFern 1-10V Controller.
◆ The antenna lead must not be shortened and damaged.
WARNING!
WARNING!
ATTENTION!
ATTENTION!
EN
25
Advertisement
Table of Contents
