i
10. Manual mode
Key to the previous table
#
If the last intermediate state has been reached, then the DuoFern
1-10V Controller stops here. No intermediate state is saved upon
connecting the mains power supply.
*
The current brightness of the lamp is saved as the intermediate state.
More information about the functionality
◆ The dimming time for manual commands can be config-
ured via the running time feature.
◆ Use the light mode if you want to operate the DuoFern
1-10V Controller together with roller shutters.
i
10.1 Operation with an external button
Brief press
Press and hold
i
10.2 Jog mode
Jog mode is available to conveniently configure the output. The
output is increased or reduced by 10% in each case.
The jog mode must be activated on the respective controller (e.g.
DuoFern Manual Transmitter) so that the corresponding control
commands are transmitted.
32
= switches ON/OFF, does not stop upon
reaching the intermediate state
= dims alternately (on to 100 % /
off to 0 %), the new dimmed value is
saved as the intermediate value.
EN