Verifying The Kit Contents; Installing Software On The Host Computer - National Instruments cRIO-9036 Getting Started Manual

Caution
Note
3. Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.

Verifying the Kit Contents

Verify that the following items are included in the cRIO-9036 kit.
1
1. cRIO Device with Power Connector and SD Card
Slot Cover
2. USB A-to-B Cable
3. Ferrite (x2)

Installing Software on the Host Computer

Before using the cRIO-9036, you must install the following application software and device
drivers on the host computer in this order:
1. LabVIEW 2014 SP1 or later
2. LabVIEW Real-Time Module 2014 SP1 or later
3. LabVIEW FPGA Module 2014 SP1 or later
4. NI-RIO Device Drivers February 2015 or later
For minimum software support information, visit
.
swsupport
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To program the user-
accessible FPGA on the cRIO-9036, LabVIEW FPGA Module is required.
Never touch the exposed pins of connectors.
Do not install a device if it appears damaged in any way.
Figure 1. cRIO-9036 Kit Contents
2 3
4. NI-RIO Device Drivers Media
5. Getting Started Guide
1
ni.com/info
NI cRIO-9036 Getting Started Guide | © National Instruments | 5
4
and enter the Info Code
5