System Reset; Status Led Indicators - National Instruments cRIO-9036 Getting Started Manual

4. Click Add.
5. Click OK.
• Ensure that UDP port 44525 is open to communication on the host computer. If you are
using an intelligent switch on the network, ensure that it is not disabling UDP port 44525.

System Reset

The following figure shows the reset behavior of the cRIO-9036.
Press and hold
RESET button for < 5 s
Press and hold RESET button for ≥ 5 s
Run Mode
Press and hold RESET button for < 5 s
Press and hold RESET button for < 5 s

STATUS LED Indicators

The following table describes the STATUS LED indicators.
14 | ni.com | NI cRIO-9036 Getting Started Guide
Figure 5. Reset Button Behavior
• Console Out enabled
Safe Mode
• RT Startup App disabled
• FPGA Startup App disabled
Press and hold RESET button for ≥ 5 s
• Console Out enabled
• Network settings reset
Safe Mode
• RT Startup App disabled
• FPGA Startup App disabled
Press and hold
RESET button for ≥ 5 s