Table of Contents
Advertisement
Caution
you must contact NI and reformat the controller.
Installing Software on the cRIO-9036
Complete the following steps to install software on the cRIO-9036.
1.
In MAX, expand your system under Remote Systems.
2.
Right-click Software.
3.
Select Add/Remove Software to launch the LabVIEW Real-Time Software Wizard.
Tip
4.
Select the recommended software set for your LabVIEW and NI-RIO Device Drivers
versions.
5.
Click Next.
6.
Select NI Scan Engine from the software add-ons.
Select any additional software to install. If you plan on using the cRIO-9036 with the
LabVIEW FPGA Module, you can click Next. Click NI Scan Engine if you plan on
using the cRIO-9036 without the LabVIEW FPGA Module.
Tip
7.
Click Next.
8.
Verify that the summary of software to install is correct.
9.
Click Next to start the installation.
10. Click Finish when the installation is complete.
Troubleshooting the cRIO-9036
The cRIO-9036 is Not Communicating with the
Network
•
Ensure that the USB connections between the cRIO-9036 and the host computer and the
Ethernet connections between the host computer and the router are secure.
•
Configure the IP and other network settings by completing the following steps.
1.
Use a USB A-to-B cable to connect the cRIO-9036 USB device port to a host
computer. The USB driver creates a virtual network interface card and assigns an IP
address to the cRIO-9036 in the format of 172.22.11.
2.
In MAX, expand your system under Remote Systems.
12 | ni.com | NI cRIO-9036 Getting Started Guide
NI cannot recover lost system passwords. If you forget the password,
You must log in if you set a system password.
You can use this wizard at anytime to install additional software.
.
x
Advertisement
Table of Contents
