Verifying The Kit Contents; Installing Software On The Host Computer; Installing C Series Modules - National Instruments cRIO-9066 Getting Started

Note
3. Unpack any other items and documentation from the kit.
Store the device in the antistatic package when the device is not in use.

Verifying the Kit Contents

Verify that the following items are included in the cRIO-9066 kit.

Installing Software on the Host Computer

Before using the cRIO-9066, you must install the following application software and
device drivers on the host computer in this order:
1. LabVIEW 2014 or later
2. LabVIEW Real-Time Module 2014 or later
3. LabVIEW FPGA Module 2014 or later
4. NI CompactRIO Device Drivers 14.0 or later
For minimum software support information, visit
Code swsupport.
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To
program the user-accessible FPGA on the cRIO-9066, LabVIEW FPGA Module is
required.

Installing C Series Modules

Complete the following steps to install a C Series module.
Do not install a device if it appears damaged in any way.
[1]
ni.com/info
cRIO-9066 Getting Started
and enter the Info
© National Instruments
7