Verifying The Kit Contents; Installing Software On The Host Computer; Installing C Series Modules - National Instruments NI cRIO-9031 Getting Started Manual

Verifying the Kit Contents

Verify that the following items are included in the cRIO-9031 kit.
1
1. cRIO Device with Power Connector and SD Card
Slot Cover
2. USB A-to-B Cable
3. Ferrite (x2)

Installing Software on the Host Computer

Before using the cRIO-9031, you must install the following application software and device
drivers on the host computer in this order:
1. LabVIEW 2014 or later
2. LabVIEW Real-Time Module 2014 or later
3. LabVIEW FPGA Module 2014 or later
4. NI-RIO Device Drivers August 2014 or later
For minimum software support information, visit
.
swsupport

Installing C Series Modules

Complete the following steps to install a C Series module.
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To program the user-
accessible FPGA on the cRIO-9031, LabVIEW FPGA Module is required.
Figure 1. cRIO-9031 Kit Contents
2
4. NI-RIO Device Drivers Media
5. Getting Started Guide
1
NI cRIO-9031 Getting Started Guide | © National Instruments | 5
3
ni.com/info and enter the Info Code
4
5