Table of Contents
Advertisement
11. When you are finished, click Done.
If you made any changes, the Save Changes dialog box appears.
12. If you want to save your changes, click Yes.
Modifying a Board in the Device Driver
Configuration
To modify a board in the device driver configuration, perform the
following steps:
1.
Open the Control Panel.
2.
Double-click the DT Imaging Control icon.
Select the DT3120 board to configure.
3.
4.
Select the Video Format as either 50 Hz or 60 Hz.
5.
When you are finished, click Done.
If you made any changes, the Save Changes dialog box appears.
If you want to save your changes, click Yes.
6.
Uninstalling the Device Driver
Generally, you will always require the DT3120 Device Driver.
However, if you are no longer using the DT3120 board with the
supported software, you can uninstall the DT3120 Device Driver
from the system by performing the following steps:
1.
Open the Control Panel.
2.
Double-click System.
Click Hardware, then click Device Manager.
3.
4.
Double-click DT Image Device.
5.
Click the DT3120 Frame Grabber, click Action, then click
Uninstall.
Click OK.
6.
Modifying the Device Driver
B
B
B
B
B
B
B
B
B
101
Advertisement
Table of Contents
