Windows 2000 Procedures
This section describes the following procedures in Windows 2000:
• Adding a board to the device driver configuration (on this page);
• Modifying the board settings in the device driver configuration
(on
page
• Uninstalling the device driver, if necessary (on
Adding a Board to the Device Driver Configuration
To add a new board to the DT3120 Device Driver configuration,
perform the following steps:
1.
Turn your computer off and insert the new DT3120 board into
your computer following the instructions in the DT3120 Getting
Starting Manual.
2.
Turn your computer on and start Windows 2000.
The Add New Hardware Wizard dialog box appears.
3.
Click Next.
4.
Click Search for a suitable driver for my device (recommended),
make sure all optional search locations are unchecked, then click
Next.
5.
Click Next.
The files are copied.
6.
Click Finish.
7.
Open the Control Panel.
8.
Double-click the DT Imaging Control icon.
Select the DT3120 board to configure.
9.
10. Select the Video Format as either 50 Hz or 60 Hz.
98); and
Modifying the Device Driver
page
98).
B
B
B
B
B
B
B
B
B
97