Windows 98 And Windows Me Procedures; Adding A Board To The Device Driver Configuration - Data Translation DT3120 User Manual

Appendix B

Windows 98 and Windows Me Procedures

Adding a Board to the Device Driver Configuration

94
This section describes the following procedures in Windows 98 and
Windows Me:
• Adding a board to the device driver configuration (on this page);
• Modifying the board settings in the device driver configuration
(on page 95); and
• Uninstalling the device driver, if necessary (on
To add a new board to the DT3120 Device Driver configuration,
perform the following steps:
1. Turn your computer off and insert the new DT3120 board into
your computer following the instructions in the DT3120 Getting
Starting Manual.
2. Turn your computer on and start Windows 98 or Windows Me.
The Add New Hardware Wizard dialog box appears.
3. Click Next.
4. For Windows 98:
Click Search for the best driver for your device
(Recommended), make sure all optional search locations are
unchecked, then click Next.
For Windows Me:
Click Automatic search for a better driver (Recommended).
5. Click Next.
The files are copied.
6. Click Finish.
7. Open the Control Panel.
8. Double-click the DT Imaging Control icon.
page 96).