Select Engineered Systems TEC Series Manual page 66

The Site Code (sometimes called a Facility Code) is used with the Card Readers.
SITE CODE
Site Code is used to identify the group of cards being used with a particular TEC. This keeps cards on
one facility from being used in another facility. The range of Site Codes is from 000 - 254.
change the Site Code from the factory default of 000, press "5" from the Communications Setup menu
to get to this sub-menu. Key in the desired 3 digits corresponding to the Site Code of the cards you
have purchased, and press "Enter" key.
NOTE: IF SITE CODE = "000" THE CARD READER FUNCTION IS DISABLED, AND CARD # WILL
NOT APPEAR IN CODE/NAMES PROGRAMMING MENU . IF SITE CODE IS SET TO 255, THE SITE
CODE ON THE CARD WILL BE IGNORED, AND SECURITY OF CARDS WILL BE REDUCED.
DIRECTORY ON / OFF
the display. The codes keyed in will still display. All names will still print to the optional printer
(OPTKPRT). To disable Directory from the factory default of 1, press "6" from the Communications
Setup menu to get this sub-menu. Press "0" to disable Directory, and press "Enter" or "*" key.
KEYPAD ON / OFF
This selection allows the keypad to remain active after dial out. This is useful for answering machines,
voice mail, and other functions requiring a Touch-Tone™ signal after communications are established.
To enable keypad from the factory default of 0, press "7" from the Communications Setup menu to get
this sub-menu. Press "1" to enable the keypad, and press "Enter" key. Only the number keys are
active, * and # will not work. Press"Enter" key. This will return you to the System Parameters menu.
SPEAKER TONE
telephone in order to listen in. When enabled, the TEC has an open audio channel to permit
conversation from someone calling in to the TEC (the microphone is also enabled at the same time).
To enable speaker from the factory default of 0 (disabled), press "8" from the Communications Setup
menu to get this sub-menu. Select a digit from 1 to 9 to enable speaker, and press "Enter" key. This
will return you to the Communications Setup menu.
UPDATE LCD (TECVISION ONLY)
This selection allows information in the TEC memory to be transferred to the display memory.
Press 9 to enable update and then press "Enter" or "*" key. This will return you to the
Communications Setup Menu.
CLOCK SETUP
DAY, 1..7: This is NOT the day of the month. This is a number which corresponds to the day of the
week. Enter a number corresponding to the day of the week. Sunday is "1", Saturday is "7" and so
forth. If you make a mistake, press <BkSpc> to backspace one character. After the day of the week is
entered, press the "Enter" key.
NOTE: ONCE TIME/DATE PROGRAMMING HAS BEGUN, ALL SELECTIONS MUST BE
COMPLETED FOR CHANGES TO TAKE EFFECT.
Page 60
This selection allows all directory names to be suppressed from
This selection allows the speaker to be activated for remote control from a
SETTING TIME / DATE
MIN.: Select "1" to set the time & date. You will be prompted to
enter the current time in minutes as a one or two digit number (0 to
59). If you make a mistake, press <BkSpc> to backspace one
character. After the minutes are entered, press the "Enter" key.
HOUR: Enter a 1 or 2 digit number (0 to 23) to set the hour. If a
mistake is made, press <BkSpc> to backspace each character.
After the hour is entered, press the "Enter" key.
TEC Series v 3.2X
To