Advertisement
FIND CARD
FIND CARD: Another selection in this sub-menu is find card reader number. The TEC system allows
one card number per code entry. These are five digit numbers used with the card reader interface. If
Facility Site code = 000, this selection may not display.
The card number that will be given to the name or group must be known. Enter this number
into memory. If you make mistakes while keying in the number, press the back arrow. This will
backspace over the mis-keyed digit. After entering the Card code number, press the "Enter" key to
place the Card code number into memory.
FIND NAME
If there is no match, you will be prompted to press "Enter" or * key from the terminal. Pressing
the "Enter" key will return to sub-menu 1 (See section on Codes / Names).
SHOW ALL CODES
SHOW ALL NAMES
Page 54
To select the find name function, press "2" from the
Codes/Names menu. You will be prompted for 1 - 6
characters. Select characters in the same manner
that you programmed names into memory. When
you have entered all desired characters, press the
"Enter" key.
This message will display whatever code
number matches the letters selected. If there is more
than one name with similar letters, pressing the press
the "Enter" key will display additional code numbers
that meet the selection criteria.
Codes:
the Codes/Names menu by pressing "8".
This selection will list code numbers and
all data associated with code numbers,
sorted by CODE NUMBER in ascending
order. It sends this data out to the
computer screen.
(CAT Shown. TEC is similar.)
Names: Select this sub-menu from the
Codes/Names menu by pressing "9". This
selection will list code numbers and all
data associated with code numbers,
sorted by NAMES in ascending order. It
sends this data out to the computer
screen.
TEC Series v 3.2X
Select this sub-menu from
Advertisement
Need help?
Do you have a question about the TEC Series and is the answer not in the manual?
Questions and answers
How to change a listed resident's phone number
To change a listed resident's phone number in the Select Engineered Systems TEC Series, you need the Manager's Password. The first three digits of the Program Password serve as the Manager's Password. Once you have access, follow these steps:
1. Enter the Communications Setup menu.
2. Use the Manager's Password to access the settings that allow phone number changes.
3. Locate the option to edit resident details, including phone numbers.
4. Input the new phone number.
5. Confirm the change by pressing the "Enter" key.
This updates the resident's phone number in the system.
This answer is automatically generated