Advertisement
SYSTEM PARAMETERS
SYS PARAM.
SELECT 1 - 9
TALK TIME
TALK TIME = 01
ALARM TIME
ALARM TIME = 10
CODE LENGTH
CODE LENGTH = 3
PIN LENGTH
PIN LENGTH = 4
BACK BEEP
BACK BEEP = 0
Page 34
The System Parameters menu comes with factory defaults
that should be sufficient for most installations. These default
values are shown on Pg. 28 and 29 Some functions work with
options that may not be present on your TEC. For example,
selection 2 Alarm Time is not valid unless the optional alarm
control relay (OPTK3R) has been purchased. To get the menu at
left, press "3" from the main menu.
Talk Time is the time in minutes from 1 - 99 minutes that
the TEC remains connected after dial out. In areas of the country
where rate usage is a concern, the factory default is 1 minute. For
other applications, the talk time can be adjusted upward by
pressing "1" from the System Parameters menu to get this sub-
menu. Key in the desired number (must be 2 digits) and press "*".
This will return you to the System Parameters menu.
Alarm time is the time in seconds that the optional alarm
relay control (OPTK3R) is energized. To change the alarm time
from the factory default of 10 seconds, press "2" from the System
Parameters menu to get this sub-menu. Key in the desired
number (must be 2 digits) and press "*". This will return you to the
System Parameters menu.
Code length is the number of digits from 1 to 6 entered on
the keypad to dial a phone from the TEC. To change the code
length from the factory default of 3 digits, press "3" from the
System Parameters menu to get this sub-menu. Key in the
desired number from 1 - 6 and press "*". This will return you to the
System Parameters menu.
PIN length is the number of digits from 0 to 6, entered from
the keypad to enter a PIN code from the TEC. To change the PIN
length from the factory default of 4 digits, press "4" from the
System Parameters menu to get this sub-menu.
desired number from 0 - 6.
SELECTING PIN LENGTH = "0" DISABLES THE PIN FUNCTION.
Press "*" to return to the System Parameters menu.
Back Beep is a background tone that will "beep" every 10
seconds when enabled. This allows a called party to determine if
someone called from a TEC. To enable the back beep from the
factory default of 0, press "5" from the System Parameters menu
to get this sub-menu. Press "1" to enable Back Beep, and press
"*". This will return you to the System Parameters menu.
TEC Series v 3.2X
Key in the
Advertisement
Need help?
Do you have a question about the TEC Series and is the answer not in the manual?
Questions and answers
How to change a listed resident's phone number
To change a listed resident's phone number in the Select Engineered Systems TEC Series, you need the Manager's Password. The first three digits of the Program Password serve as the Manager's Password. Once you have access, follow these steps:
1. Enter the Communications Setup menu.
2. Use the Manager's Password to access the settings that allow phone number changes.
3. Locate the option to edit resident details, including phone numbers.
4. Input the new phone number.
5. Confirm the change by pressing the "Enter" key.
This updates the resident's phone number in the system.
This answer is automatically generated