Advertisement
TEC Series v 3.2X
CLEAR ACCESS LEVELS
Pressing "4" causes this selection to clear all access levels of any previously programmed data.
Press "1" to Clear, "0" to Abort. Press "*" to return to the Main menu.
CLEAR ACCESS GROUPS
Pressing "5" causes this selection to clear all access groups of any previously programmed data.
Press "1" to Clear, "0" to Abort. Press "*" to return to the Main menu.
CLEAR ENTRANCES
Pressing "6" causes this selection to clear all entrance data. Press "1" to Clear, "0" to Abort. Press "*"
to return to the Main menu.
CLEAN DIRECTORY CODES
Pressing "7" causes this selection to clean the corrupted directory codes. Press "1" to Clear, "0" to
Abort. Press "*" to return to the Main menu.
DISPLAY DATA
with an optional printer (OPTPRT), or a CRT or terminal for sub-
menu choices 1 through 5. Data is sent to the optional serial port.
It is used to print various parameters, such as Time Zones,
Holidays, Access Levels, Access Groups and general Information.
Sub-menu choices 6 through 9 send data to the LCD display on
the front panel of the Tec. To select this function, press "9" from
the Main Menu. You will see the display, shown to the right.
Pressing any selection from "1" to "5" will cause the display at
right, to be shown briefly.
Next, this message will be shown. Press "*" to return to the sub-
menu and print out other information
PRINT INFO
Pressing "1" will send the system configuration information (like the example below) for this TEC to a
CRT or printer.
PRINT TIME ZONES
Pressing "2" will send time zones
to a CRT or printer.
ZONE STIME
0
00:00
1
07:45
2
16:30
3
00:00
Pressing the menu election "9" is used
VER 3.XX
CODE CAP = 0110
PHONE CAP = 0100
CODE LENGTH = 3
PIN LENGTH = 4
CR BIT TYPE = 1
ENA ACC GRP = 0
PRESS # TO VIEW
DIRECTORY
PROGRAM PSWD = 777777
ETIME SMTWTFSH
23:59
1234567---
08:30
-23456-----
17:15
-23456-----
00:00
---------------
SETUP AND PROGRAMMING
DISPLAY DATA
SELECT 1 - 5
PRINTING BUSY
PLEASE WAIT
DISPLAY DATA
SELECT 1 - 5
(TECs with optional clock, only.)
continued
ZONE STIME
4
00:00
5
00:00
6
00:00
7
00:00
ETIME SMTWTFSH
00:00
---------------
00:00
---------------
00:00
---------------
00:00
---------------
Page 47
Advertisement
Need help?
Do you have a question about the TEC Series and is the answer not in the manual?
Questions and answers
How to change a listed resident's phone number
To change a listed resident's phone number in the Select Engineered Systems TEC Series, you need the Manager's Password. The first three digits of the Program Password serve as the Manager's Password. Once you have access, follow these steps:
1. Enter the Communications Setup menu.
2. Use the Manager's Password to access the settings that allow phone number changes.
3. Locate the option to edit resident details, including phone numbers.
4. Input the new phone number.
5. Confirm the change by pressing the "Enter" key.
This updates the resident's phone number in the system.
This answer is automatically generated