Advertisement
TEC Series v 3.2X
Setup refers to configuration of a TEC, usually during installation. This may include how long the door
entry time is, or what number energizes the door control relay. Any options such as card readers or
automatic unlock and re-lock, are configured at this time. The installer of the TEC generally performs
these tasks.
Programming refers to the entry of codes, names, phone numbers, and PINs (Personal
Identification Numbers). The end user or customer generally enters the data, and periodically updates
it as required.
If the factory defaults shown on Pg. 28 and 29 are adequate for an installation, then the
following "Quick Programming" section will give an example of a typical code entry. No explanations
about menu selection function will be provided. SES strongly recommends that installers without
previous experience in telephone entry control systems read this manual in it's entirety.
QUICK KEYPAD PROGRAMMING EXAMPLE
This example assumes all factory defaults, including factory default passcode 777777 are in
the TEC and you have entered no other data. This benefits those with experience installing and
programming telephone entry systems.
This example enters the following data into the TEC from the keypad on the TEC front door:
CODE:
NAME:
001
SMITH,FRED 555-1234
123
DOE,JOHN
1.
To begin programming press the "*" and the "0" keys simultaneously.
2.
Enter passcode number 777777.
3.
Press *.
4.
Press 1.
5.
Press 1.
6.
Press 001*.
7.
Press 777#6#444#8#44#1111#333#77#33#3#*5551234*1234*.
8.
Press 123 *.
9.
Press 3#666#33#1111#5#666#44#66#*5559876*5678*.
10. Press the "*" and the "0" keys simultaneously.
Press the # key twice. You should see both codes and names in the display (one after the
other). If you had any problems entering the data, or if you did not understand the reason for a key
entry, please read the rest of this manual.
PHONE:
PIN:
1234
555-9876
5678
SETUP AND PROGRAMMING
Page 25
Advertisement
Need help?
Do you have a question about the TEC Series and is the answer not in the manual?
Questions and answers
How to change a listed resident's phone number
To change a listed resident's phone number in the Select Engineered Systems TEC Series, you need the Manager's Password. The first three digits of the Program Password serve as the Manager's Password. Once you have access, follow these steps:
1. Enter the Communications Setup menu.
2. Use the Manager's Password to access the settings that allow phone number changes.
3. Locate the option to edit resident details, including phone numbers.
4. Input the new phone number.
5. Confirm the change by pressing the "Enter" key.
This updates the resident's phone number in the system.
This answer is automatically generated