Advertisement
SETUP AND PROGRAMMING
TRANSACTION BUFFER INFORMATION continued
VIEW LOG
LCD display as shown at left. The TEC will sound a long error beep and return to the Buffer
Information menu.
SEND LOG
PRINTING BUSY
PLEASE WAIT
BUFFER INFO
SELECT 1 - 4
TRANSACTION BUFFER FREE
BUFF FREE = 70%
SEND LOG
ERASE LOG
CONTINUE? 1/0
CLEAR DATA
SET PARAMETERS
CLEAR DATA
CLEAR TIME ZONES
Pressing "2" causes this selection to clear any previously programmed time zone and resets all
times to 00:00. Press "1" to Clear, "0" to Abort. Press "*" to return to the Main menu.
CLEAR HOLIDAYS
Pressing "3" causes this selection to clear all Holidays from memory. This is useful for Holidays
that are observed on different days from year to year, such as Thanksgiving or Labor Day. Press "1" to
Clear, "0" to Abort. Press "*" to return to the Main menu.
Page 46
This allows the log to be viewed from a terminal connected to the
optional serial port. The log also may be viewed from a personal
computer communicating through the optional modem. Pressing
"1" from the front panel keypad will only show a cursor box in the
Pressing "2" will send all logging data to either the
optional serial port or to the optional modem, if you are using a
terminal through the modem.. A message like the one at left will
display.
After all data stored in the buffer has been sent, the
message shown at left will display. Press "*" to return to the
Buffer Information menu. Press "*" again, to return to the Main
menu.
Pressing "3" from the front panel keypad will only show
the approximate amount of space remaining in the buffer A
message similar to left will appear
Press "4" to get to the menu at left. Pressing a "1" then "*"
clears all transactions stored in the buffer for the TEC. If you
press a "1" by mistake, press "#" and "0" simultaneously to
backspace over the "1". Press "0" then "*" to return to the main
menu. If you press any key other than "1", the TEC will sound a
long error beep. Press "*" to return to the Buffer Information
menu. Press "*" again, to return to the Main menu.
Pressing "1" returns all Entrance Control, System
Parameters and Communication Setup settings to the SES
factory defaults. These defaults are shown on Pg. 28 and 29.
Press "1" to reset the parameters
TEC Series v 3.2X
Advertisement
Need help?
Do you have a question about the TEC Series and is the answer not in the manual?
Questions and answers
How to change a listed resident's phone number
To change a listed resident's phone number in the Select Engineered Systems TEC Series, you need the Manager's Password. The first three digits of the Program Password serve as the Manager's Password. Once you have access, follow these steps:
1. Enter the Communications Setup menu.
2. Use the Manager's Password to access the settings that allow phone number changes.
3. Locate the option to edit resident details, including phone numbers.
4. Input the new phone number.
5. Confirm the change by pressing the "Enter" key.
This updates the resident's phone number in the system.
This answer is automatically generated