Advertisement
ENTRANCE X LATCH TONE
The Entrance X latch tone refers to the touch tone numbers that allow the entrance to
automatically latch open when called in remote control mode. To change the number from the
default setting of 0 to another number, press "4" from the ENT 1 Control menu. Select the new
number (from 0 - 9) and press the "Enter" key. You will be returned to the Entry Control menu.
SELECTING A "0" DISABLES THE LATCH TONE FUNCTION. Selecting a number from 1 - 9 allows
that number to automatically latch open the door for that entrance.
NOTE: IF ENT X TONE AND ENT X LATCH ARE THE SAME NUMBER, THE ENT 1
RELAY WILL NOT LATCH OR TIME OUT. IT WILL ENERGIZE BRIEFLY, AND THEN
DE-ENERGIZE.
ENTRANCE X AJAR TIME
Press "5" from the Entry Control menu to set the ajar time. The ajar time is the length of time an
entrance may be left ajar before energizing the optional alarm relay. This time is programmable from
1—99 seconds. Default is 0 (Off)
(CAT Shown. TEC is similar.)
Page 56
TEC Series v 3.2X
Advertisement
Need help?
Do you have a question about the TEC Series and is the answer not in the manual?
Questions and answers
How to change a listed resident's phone number
To change a listed resident's phone number in the Select Engineered Systems TEC Series, you need the Manager's Password. The first three digits of the Program Password serve as the Manager's Password. Once you have access, follow these steps:
1. Enter the Communications Setup menu.
2. Use the Manager's Password to access the settings that allow phone number changes.
3. Locate the option to edit resident details, including phone numbers.
4. Input the new phone number.
5. Confirm the change by pressing the "Enter" key.
This updates the resident's phone number in the system.
This answer is automatically generated