Table Of Contents; General Instructions; Tools And Supplies Needed - Kasco 2400VFX Operation & Maintenance Manual

Contents
General Instructions ���������������������������������������������
Tools and Supplies Needed ����������������������������������
Important Safety ���������������������������������������������������
Unit Specs & Pattern Size ������������������������������������
Parts Included �������������������������������������������������������
Assembly Instructions �������������������������������������������
Unit Installation Instructions ����������������������������������
Control Panel Installation ��������������������������������������

GENERAL INSTRUCTIONS

INSPECT THE SHIPMENT: Immediately inspect your Kasco Aerator shipment for any visible damages� Also cross-reference the parts
supplied with the Parts Included sheet to check for shortages� Shortages should be reported immediately to your Kasco Marine distrib-
utor or representative and damages reported to your carrier and Kasco Marine�
ASSEMBLY & INSTALLATION: Please see the proper Assembly and Installation Instructions enclosed in this manual. Each is specific
for your model and size of aerator�
• Use a nylon tie to help keep the power cords for the unit and lights free of the propeller by tying each cord to either side of
the float. If you have a light kit, make sure that the unit cord is tied to one side of the float and the light cord to the other for
balance�
• It is extremely important to test the GFI breaker in the control panel upon each installation/re-installation of the unit to ensure
proper functioning�
USE AND OPERATION: Kasco aerators are designed and engineered for continuous duty, such as on fish farms or other aquaculture
applications, or on-demand use, as needed in a recreational water feature. During flotation operation, the water is pulled from 360 de-
grees around the unit and from below the unit. The water is pulled upward and thrust through the flotation collar into the air. Your Kasco
Marine aerator is ready for immediate use (after installation)� Make sure to keep the motor housing clean from hard water deposits and/
or algae. (See Maintenance Recommendations.) It is extremely important that proper and sufficient voltage is supplied to the aerator
motor. Unit should be protected by a GFCI. Control panels must be installed by a qualified electrician. (See Installation instructions).

TOOLS AND SUPPLIES NEEDED

• 7/16" socket and ratchet
• 7/16" wrench
• 11/32" wrench (for #8 fasteners)
2400 - 4400 VFX DECORATIVE AERATOR
C-25 Timer Control Instructions ������������������������
2
C85 / C95 Non-Metallic Control Panel Timer����
2
Replacement Parts �����������������������������������������
3
Maintenance Recommendations ��������������������
3
Repair �������������������������������������������������������������
4
Non-Warranty Repairs ������������������������������������
5
Troubleshooting Tips ��������������������������������������
6
Repair Contact Form ��������������������������������������
7
7/16'' combination wrench
11/32" wrench
This Kasco product is the result of years of innovation, and we are confident that
you will be impressed with its quality and performance� If you have any questions
about assembly, installation, or maintenance, please reach out to our friendly and
knowledgeable customer care team� Thank you for trusting Kasco�
715.262.4488
2
7/16'' socket
www.kascomarine.com
MANUAL
8
9
10
11
12
13
14
15
sales@kascomarine.com
884170 / 2021.1.1