ADTRAN NetVanta 1560-08-150W Quick Start Manual page 2

Installation Overview
To install the switch, you will need to do the following:
1. Mount the switch
2. Connect AC Power
3. Install SFP Modules
Installation Steps
To install the NetVanta 1560-08-150W switch, complete the following steps:
Mount The Switch
The switch can be mounted in a 19-inch rack, on a desk or shelf, or on a wall.
Mounting in a 19-inch Rack
g
NOTE
Mounting brackets are not included. Mounting brackets may be ordered from ADTRAN using the following part number: 1700518F1
To mount the switch into a 19-inch rack, complete the following steps.
1. Attach the mounting brackets to both sides of the chassis. Insert the screws and tighten them with a screwdriver to secure the brackets.
2. Place the switch on a rack shelf in the rack. Push it in until the oval holes in the brackets align with the mounting holes in the rack posts.
3. Secure the brackets to the posts by inserting rack screws and tightening them with an appropriate screwdriver.
Mounting on a Desk or Shelf
To mount the switch on a desk or shelf, complete the following steps.
1. Verify that the desk or shelf is sturdy enough to support the switch.
2
Figure 3. Attaching Brackets to the Switch
Figure 4. Attaching Brackets to the Rack Post
617108108PF2-13D