3M -Matic 700r3 Instructions And Parts List page 32

7-INSTALLATION AND Setup (continued)
Column Guards
Buffi ng
Buffing Cable
Roller
Roller
WARNING
Sharp Knife
Note:
Column Guards
are removed
before
Installing the
Bumper Supports
(see Figure 2-6
and Figure 6-1).
Column Guards
are then reinstalled
(as shown in a ro-
tated 180° position)
Figure 7-7 – 700r3 Frame Setup
7. Hold taping head BUFFING ROLLER and cut
and remove cable tie that holds applying/buffi ng
arms retracted (Applying/buffi ng rollers are held
retracted for shipment - See Figure 7-6).
Allow buffi ng/applying arms to extend slowly.
Also cut and remove cable tie at rear
of lower taping head.
WARNING
To reduce the risk associated with sharp
•
blade hazards:
− Keep hands and fi ngers away from tape
cutoff blades under orange blade
guards. The blades are extremely sharp.
8. Check for free action of both upper and lower
taping heads. Push buffi ng roller into head to
check for free, smooth action of taping heads.
700r3-NA
C
C
Cable
Tie
Tie
To reduce the risk associated with sharp
•
blade hazards:
− Keep hands and fi ngers away from tape
cutoff blades under orange blade
guards. The blades are extremely sharp.
9. Ensure that the tape drum bracket assembly,
located on the lower taping head, is mounted
straight down, as shown in Figure 7-8A. The
tape drum bracket assembly can be pivoted to
provide tape roll clearance in certain cases.
22
A
B
WARNING
2012 January