One-Way Tension Roller; Tape Leg Length; Leading Tape Leg Length Adjustment; Changing Tape Leg Length From 70 To 50 Mm [2-3/4 To 2 Inch] - 3M -Matic 700r3 Instructions And Parts List

Adjustments (continued)
WARNING
•
To reduce the risk associated with shear,
pinch, and entanglement hazards:
−
Turn air and electrical supplies off on
associated equipment before performing any
adjustments, maintenance, or servicing the
machine or taping heads
−
Never attempt to work on the taping head
or load tape while the box drive system is
running

Tape Leg Length

WARNING
•
To reduce the risk associated with sharp
blade hazards:
−
Keep hands and fi ngers away from tape
cutoff knives under orange blade guards.
The blades are extremely sharp
Leading Tape Leg Length Adjustment – Figure 5-6
The one-way tension roller position is adjustable to
control the leading tape leg length.
Moving this roller farther away from the box top or
bottom surface will decrease the leading leg length.
Moving it closer to the box top or bottom surface will
increase the leading leg length.
Changing Tape leg Length from 70 to 50mm [2-3/4 to
2 inches] – Figure 5-7
Note – When changing tape leg length, both upper
and lower heads must be adjusted to apply the
same leg lengths.
1. Remove and retain two hex head screws and
remove the brush from normal position "A" on side
frame.
2. Remount and secure brush in position "A-A" on
side frame forward of normal location using original
fasteners.
3. Remove cut-off bracket extensions from position "B".
4. Remount cut-off bracket extensions in forward
position "B-B".
5. Remove and retain the one-way tension roller
assembly from slot "C" in frame.
6. Remount tension roller assembly near top of slot
"C-C" in frame using original fasteners.
7. Adjust tension roller according to "Leading Tape Leg
Length Adjustment" above.
AccuGlide 3 - 3" - NA
Tape Leg
50 or 70mm ± 6mm
[2 or 2-3/4in. ± 1/4in.
Figure 5-6 – Leading Tape Leg Length
Position A
Position A-A
Position B
Brush
Position B-B
Figure 5-7 – Changing Tape Leg Length
16
One-Way
Tension
Roller
One-Way
Tension Roller
Assembly
Slot C-C
Slot C
Cut-Off
Bracket
Extension
2012 January