Table of Contents
Advertisement
3 How to get started (GigE G2)
4.
Select a valid IP address for selected camera (see Fig. 3.12). There should be no
exclamation mark on the right side of the IP address. Click on Ok in the Set IP Address
dialog. Select the camera in the GEV Device Selection dialog and click on Ok.
Figure 3.12: Setting IP address
5.
Finish the configuration process and connect the camera to PF_GEVPlayer .
Figure 3.13: PF_GEVPlayer is readily configured
6.
The camera is now connected to the PF_GEVPlayer. Click on the Play button to grab
images.
An additional check box DR1 resp. QR1 appears for DR1/QR1 cameras. The camera
is in double rate mode if this check box is checked. The demodulation is done
in the PF_GEVPlayer software. If the check box is not checked, then the camera
outputs an unmodulated image and the frame rate will be lower than in double
rate mode.
24 of 103
MAN066 12/2018 V1.1
Advertisement
Table of Contents
