QDI WinneX3E Manual page 46

RecoveryEasy
b. If choosing to install RecoveryEas y on an absolutely clear disk, the utility w ill
delete all the previous partitions.
c. The passw ord is set as default setting "qdiqdi" after installing RecoveryEasy.
1.1 CREATE PAR
Function : Creates a new partition.
Lim itation : When no disk space remains or 4 partitions already exist, this button is
disabled.
Steps : After pressing the "CREATE P AR" button.
a. The system w ill prompt w hether users w ant to create a mirror partition for it or
not.
b. If answ ering "Y", input the new partition size in Megabyte. Notice that the
maximum partition size that can be assigned is half of the left disk space, w hich
is also displayed in the status line. Another half is for the mirror partition. If
answ ering "N", the w hole disk space left can be assigned. See figure-2.
Note:
a. The system w ill prompt "Insert system floppy, then reset" w hen the first
partition on the first hard disk is created.
b. After using DOS6.xx boot disk to format C partition, the system should be reset in
order to access the partition.
c. In Window s system 1,048,576 bytes equal 1 Megabyte, w hile in Recover yEasy
1,000,000 by tes equal 1 Megabyte, therefore a smaller size w ill be displayed in
Window s system compared w ith the size displayed in RecoveryEasy.
1.2 DELETE PAR
Function : Deletes the last partition and its mirror partition.
Lim itation : When no partition exists, this button is disabled.
Steps : After choosing this function, only the final partition can be deleted in
order to keep the continuous disk space. If the w arning message is
confirmed, the partition w ill be deleted. By pressing "N" or "ESC" key,
the system quits.
figure- 2 Create Par tition
Manual for WinneX 3E