Table of Contents
Advertisement
3.
An ACPI-enabled operating system such as Window s 98 is needed.
Navigate to the CD-ROM drive fr om the MS-DOS Command Prompt and enter the
follow ing from the Win98 dir ectory on the CD:
(This manual assumes that y our CD-ROM device driv er letter is D:)
Window s 98 w ill be installed w ith ACPI enabled.
4.
Three w ays to enter Suspend-to-RAM s tatus under ACPI-enabled Window s 98:
Click Start -> Shut dow n -> Standby to enable the system to enter Sus pend-to-
l
RAM status.
Clic k Start -> Setup -> Control Panel -> Pow er Management -> A dvanced and
l
choose Standby item, the system w ill enter Suspend- to-RAM status w hen you
press pow er button.
From Pow er Management Properties in Control Panel, set the latency time in
l
System Standby, the system w ill enter Suspend-to-RAM status w hen time out.
The s ame w ays used to pow er up the system can be used to w ake up the system from
Suspend-to-RAM status. For example, pushing the pow er button, through the Wake-on-
LAN, Wake-on-Modem function or RTC Alarm. If the keyboard pas sw ord pow er-on func-
tion is enabled, the keyboard passw ord should be used to w ake up the sy stem instead of
pushing the pow er button.
Ultra ATA/66
According to the previous ATA/IDE hard drive data transfer protocol, the signaling w ay to
send data w as in synchronous strobe mode by using the rising edge of the str obe signal.
The Ultra ATA/33 protocol doubles the burst trans fer rate fr om 16.6MB/s to 33.3MB/s, by
using both the rising and falling edges of the strobe signal, this time Ultra ATA/66 doubles
the Ultr a ATA burs t tr ansfer rate onc e again (f rom 33.3MB/s to 66.6MB/s ) by reduc ing
setup times and increasing the str obe rate. The faster strobe r ate increases EMI, w hich
cannot be eliminated by the standard 40-pin cable used by ATA and Ultra ATA. To eliminate
this increase in EMI, a new 40-pin, 80-conductor cable is needed. This cable adds 40
additional ground lines betw een eac h of the original 40 ground and signal lines . The
additional 40 lines help shield the signal f rom EMI, r educe cros stalk and improv e signal
integrity.
D:\SETUP /P J
Manual for WinneX 3E
Chapter 1
Advertisement
Table of Contents
