Table of Contents
Advertisement
Installing the Jump Board
To install the Jump Board perform the following:
Lower the Footbar and Support Bar.
1
Slide the Jump Board pegs into the holes located on the Standing Platform with
2
the padded end facing the carriage.
Using the Long/Short Box
Use the Long/Short box by following the directions below.
To use as a Long box:
Place the headrest in the flat position and foot bar and foot bar support bar in the storage position.
1
Place the box lengthwise on the carriage cushion, butting one end against the shoulder pads.
2
To use as a Short box:
Place the headrest in the flat position and foot bar and foot bar support bar in the storage position.
1
Place the box on the carriage cushion with one of the long sides resting against the cushioned
2
surface of the shoulder pads.
Stacking the fit
The fit
reformer is unique in its design and can be easily stacked without the removal of any parts.
TM
Place the gear bar and gear block in position 3.
1
Make sure at least the center spring remains hooked to the gear bar.
2
Place the foot bar and bar support bar in the storage position making sure that the support bar is
3
full engaged.
WARNING
!
16
fit
reformer owner's manual
™
PeakPilates Fit Owners Manual-2021.indd 16
PeakPilates Fit Owners Manual-2021.indd 16
reformer
™
VERIFY THAT THE FOOT BAR SUPPORT BAR IS FULLY ENGAGED IN ITS
STORAGE SLOT BEFORE ATTEMPTING TO LIFT A MACHINE.
OPERATION
8/9/21 9:42 AM
8/9/21 9:42 AM
Advertisement
Table of Contents
