Table of Contents
Advertisement
OPERATION
Pull the pin on each riser and make sure that they drop to their lowest position..
4
For the upper machine: Hook each double loop strap onto its respective storage post located
5
behind the shoulder pad.
For the lower machine: Slide the double loop straps off of the storage posts and drop into the
6
well of the reformer.
Hook the foot strap into its storage loop.
7
With one person at each end, lift the reformer by grasping the underside of the frame members.
8
Do not use the foot bar as a handle to lift the reformer.
Nest the units by lining up the head end and foot end legs respectively and lowering the top unit into
9
the well of the machine below. Use caution to ensure that fingers and clothing do not get caught
between each reformer when stacking.
CAUTION
VERIFY THAT THE ALL FOUR STACKING BUMPERS OF THE UPPER UNIT TOUCH THE TOPS OF THE LOWER
UNIT RAILS OF THE BEFORE ATTEMPTING TO STACK ADDITIONAL MACHINES. DO NOT STACK OVER 4 UNITS
HIGH FOR STABILITY.
Vertically Storing the fit
To vertically store the fit
Place the gear bar and gear block in the -1 position.
1
Make sure that at least the center spring is hooked onto the gear bar.
2
Place the foot bar in its highest position.
3
Hook the foot strap into its storage loop.
4
PeakPilates Fit Owners Manual-2021.indd 17
PeakPilates Fit Owners Manual-2021.indd 17
reformer
™
reformer:
™
www.peakpilates.com
17
8/9/21 9:42 AM
8/9/21 9:42 AM
Advertisement
Table of Contents
