Ch1 (Central Heat, One) 1; Ch2 (Central Heat, Two) 2; Dhw (Domestic Hot Water) - Bradford White OmniTech BONH1250 Installation And Operation Instructions Manual
Category ii and iv venting with touchscreen controls
Hide thumbs
Also See for OmniTech BONH1250:
Table of Contents
Advertisement
Page 62
8.C.1.a
CH1 (Central Heat, One)
• Enable/Disable – This allows CH1 to be enabled/disabled. The default setting is Enabled.
• Set Point – This is the set point temperature.
8.C.1.b
CH2 (Central Heat, Two)
To navigate to the CH2 Quick Start Screen, touch the CH2 Icon on the CH Quick
Start Selection Screen. The CH2 screen will have the same look and functionality
as the CH1 Screen.
8.C.2 DHW (Domestic Hot Water)
"DHW" stands for "domestic hot water." To navigate to the DHW/DHW3 Quick Start Screen, touch the DHW icon on
the Quick Start Screen.
The DHW/DHW3 Quick Start Screen allows adjustment of the following parameters:
• Enable/Disable – This allows DHW/DHW3 to be enabled/disabled. The default setting is Enabled.
• Set Point – This is the hot water set point temperature.
NOTE: A DHW/DHW3
heat demand can be
initiated by an aquastat
or sensor , while
CH1-2(DHW1-2) are
activated by
aquastat only.
See Section SECTION
7 on page 34
Q U I C K S T A R T
1
2
Advertisement
Table of Contents
