Verification Menu - Bradford White OmniTech BONH1250 Installation And Operation Instructions Manual
Category ii and iv venting with touchscreen controls
Hide thumbs
Also See for OmniTech BONH1250:
Table of Contents
Advertisement
Page 106
9.F
Verification Menu
Verification is a required process when changes to safety parameters are made. Verification forces a review of the
changes made and allows those changes to be accepted.
1.
When a setting is changed that requires verification a notification will appear at the bottom of the screen.
Press the Verify Safety Parameters button to proceed to the verification process.
2.
Select begin to start the verification process
3.
Select yes if the parameter change is correct. Select No if the parameter change is incorrect. If No is selected
the parameter must be changed to the correct setting and the verification process started again.
4.
If yes is selected, press the reset button on the gas valve face when prompted to complete the verification
process.
Advertisement
Table of Contents
