Table of Contents
Advertisement
Q U I C K S T A R T
Page 66
LAARS Heating Systems
1
8.C.1.a CH1 (Central Heat, One)
• Enable/Disable – This allows CH1 to be enabled/disabled. The default setting is Enabled.
• Set Point – This is the set point temperature.
2
8.C.1.b CH2 (Central Heat, Two)
To navigate to the CH2 Quick Start Screen, touch the CH2 Icon on the CH
Quick Start Selection Screen. The CH2 screen will be have the same look and
functionality as the CH1 Screen.
8.C.2 DHW (Domestic Hot Water)
"DHW" stands for "domestic hot water." To navigate to the DHW Quick Start Screen, touch the DHW icon on the
Quick Start Screen.
The DHW Quick Start Screen allows adjustment of the following parameters:
• Enable/Disable – This allows DHW to be enabled/disabled. The default setting is Enabled.
• Set Point – This is the hot water set point temperature.
NOTE: A DHW heat
demand can be initiated
by an aquastat or sensor,
see Section 7.E.3 on
page 41
Advertisement
Table of Contents
