Advertisement
If a bulb is burned out, replace it to hlelp avoid an
accident. If the arrows don't go on at all when you
signal a turn, check the fuse (see "Fuses and Circuit
Breakers'' in the Index) and for burned-out bulbs.
Headlamp High/Low Beam Changer
To change the headlamps from low b'earn to high
or
high beam to low, pull the turn signal lever all the way
toward you. Then release it.
When the high beams are
on, this light on the
instrument panel
also
Windshield Wipers
I
You control the windshield wipers by moving the stalk
with the windshield wiper symbol on it up or down.
Flash-to-Pass
This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass.
To use it, pull
the turn
signal/multifunctioa lever
toward
you until the high-beam headlamps come on, then
release the lever to turn them off.
For a single wiper cycle, press the stalk down until the
wipers start, then let go. The wipers will stop after
one cycle. For more cycles, hold the wiper stalk
down longer.
2-34
Advertisement
