Advertisement
Setting the Tone
EQUALIZER: A seven band equalizer is part of your
audio
system. Slide the levers up
to
boost or down to
reduce frequency range.
Adjusting the Speakers
BAL: Press this
knob lightly so it extends. Turn it to
move the sound to the left or right speakers. The middle
position balances the sound between
the
speakers.
FADE:
Press this knob lightly so it extends. Turn it to
move the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
Push these knobs
back
into their stored positions when
you're not using them.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that are so thin they may not work well in this player.
While the tape
is
playing, use the VOL, FADE and BAL
controls just as you do for the radio. The display will
show an arrow to show which side of the tape is playing.
When
the
down indicator arrow is
lit,
selections listed
on the bottom side of the cassette are playing. When the
up arrow is lit, selections listed on the top side of
the
cassette are playing. The tape player automatically
begins playing the other side when it reaches the end
of the tape.
If E and a number appear on the radio display, the tape
won't play because of an error.
E10: The tape is tight and the player can't turn the
tape hubs. Remove the tape. Hold the tape with the
open end down and try to turn the right hub
counterclockwise with a pencil.
Turn
the tape over
and repeat. If the hubs do not turn easily, your tape
may be damaged and should not be used in the
player. Try a new tape to make sure your player is
working properly.
E l l : The tape is broken. Try
a new tape.
If any error occurs repeatedly or if an error can't be
corrected, please contact your dealer. If your radio
displays an error number, write it down and provide it to
your dealer when reporting the problem.
PREV (1): Press this button or the SEEK down arrow
to
search for the previous selection
on the
tape. Your tape
must have at least three seconds of silence between each
selection for PREV or SEEK to work, The tape direction
arrow blinks during PREV or SEEK operation. Press
PREV or the SEEK down arrow to stop searching. The
sound will mute during PREV
or
SEEK
operation.
3-14
Advertisement
