Advertisement
Center High-Mounted Stoplamp
(Models Without a Spoiler)
To change the bulb,
do
the following:
1. Open the trunk and view the access hole under the
rear shelf.
2.
Remove the bulb sockets by rotating, in either
direction, then pull down.
3. Remove the bulb and replace.
4. Reinstall the new bulb and socket into the center
high-mounted stoplamp.
Center High-Mounted Stoplamp
(Models With a Spoiler)
To change the bulb, do the following:
1. Use a torx screwdriver to unscrew the bulb assembly
from
the spoiler.
2. Gently pull out the bulb assembly.
3. Remove the bulb(s) by gently wiggling the bulb
4. Replace the bulb(s) and reverse these steps
. ..
to redace
from the assembly.
the bulb assembly.
Interior Lamps
Dome Lamp With Integral Reading Lamps
To replace a bulb, do the following:
1.
Insert a flat screwdriver into the slot at the rear of
the lens.
2. With the screwdriver, push the tab rearward to
3. Push the lens forward to release the two tabs at the
release the lamp lens,
front of the lens.
4. Gently remove and replace the bulb(s).
5. Reverse these steps to replace the lens.
Dome Lamp Without Integral Reading Lamps
To replace a bulb, do the following:
1. Fr'om the rear of the dome lamp lens, insert a flat
screwdriver between the roof trim and the lens.
2. With the screwdriver, push the tab at the rear of the
3. Pull the lamp lens rearward to release the two front tabs.
4. Gently remove and replace the bulb(s).
5. Reverse these steps to replace the lens.
lens forward to release the lens.
Advertisement
