Table of Contents
Advertisement
Service & Appearance Care
Automatic Tinsaxle Fluid
(CONX:)
Then, Without Shutting Off the
Engine, Follow These Steps:
1. Pull
out the dipstick and wipe it with
a clean rag or paper towel.
2. Push it back in all the way, wait three
seconds and then pull it back out
again.
3.
Check both sides of the dipstick, and
read the lower level. The fluid level
must be in the cross-hatched area.
4.
If
the fluid level is where it should
be, push the dipstick back in all the
way.
3.1L V6:
Checking Automatic
Transaxle Fluid
3800 V6:
Checking Automatic
Transaxle Fluid
How To Add Fluid:
Refer to the Maintenance Schedule to
determine what kind of transaxle fluid to
use.
See
the Index under
Fluids
&
Lubricants.
If the fluid level is low, add only enough
of the proper fluid to bring the level in
the cross-hatched area on
the
dipstick.
It doesn't take much fluid, generally less
than a pint (0.5 L). Don't overfill. We
recommend you use only fluid labeled
DEXRON@-IIE, because fluids with that
label are made especially for your
automatic transaxle. Damage caused by
fluid other than DEXRON@-IIE is not
covered by your new vehicle warranty.
After adding fluid, recheck the fluid
level as described under How to Check.
When the correct fluid level is obtained,
push the dipstick back in all the way.
Advertisement
Table of Contents
