Table of Contents
Advertisement
. . I
Service & Appearance Care
ladiator Pressure Cap
NOTIICE
I
Your radiator cap is a 15 psi
(105
kPa)
pressure-type cap and
must be tightly installed to prevent
coolant loss and possible engine
damage from overheating. Be sure
the arrows on the cap line up with
the overflow tube on the radiator
filler neck.
a e n you replace your radiator pressun
ap, an AC@ cap is recommended.
38
Thermostat
Engine coolant temperature is controlled
by a thermostat in the engine coolant
system. The thermostat stops the flow of
coolant through the radiator until the
coolant reaches a preset temperature.
When you replace your thermostat, an
AC@ thermostat is recommended.
Power Steering Fluid
How to Check Power Steering Fluid:
Unscrew the cap and wipe the dipstick
with a clean rag. Replace the cap and
completely tighten it. Then remove the
cap again and look at the fluid level on
the dipstick.
When the engine compartment is hot,
the level should be at the H (Hot)
mark.
the level should be at the
C
(Cold)
mark.
When the engine compartment is cool,
Advertisement
Table of Contents
