SETTING THE DRIVE SCAN ON THE MFM
Step 17
The Drive Scan is already properly configured on the MFM
Configure the Eth1 Ethernet network interface
Use DHCP: enable/disable the use of DHCP;
Default Route: enable/disable the use of default network route for the destination address of
the IP packets;
IP Address: Ethernet interface IP address;
Network Mask: network mask related to the IP address of the Ethernet interface;
Gateway: Gateway network IP address;
DNS 1: First DNS server IP;
DNS 2: Second DNS server IP.
Configure the RS-485 serial network interface
Speed: baudrate;
Bits: number of communication bits;
Parity: communication parity:
–
–
6
–
Stop bits: number of communication stop bits.
Click on "Save Configuration"
Wait for the Drive Scan to restart, and it will be ready to be operated
Low Voltage Devices | 6-12
none,
even,
odd
(Figure
Figure 6.20: Drive Scan linked to the MFM
Figure 6.21: Ethernet network configuration
(Figure
(Figure
6.21).
(Figure
6.22).
6.22).
6.20).
(Figure
6.20).