WEG Drive Scan Manual page 49

SETTING THE DRIVE SCAN ON THE MFM
Step 6 Make the settings for the connection to the Wi-Fi internet network, as shown in
SSID (Service Set Identifier): Wi-Fi network name;
Default Route: enable/disable the use of the default network route for the destination address
of IP packets;
Security: defines the Wi-Fi network access protection mode to be used:
–
–
–
–
EAP Type: defines the network authentication framework to be used:
–
–
–
–
–
Identity: username to authenticate to the Wi-Fi network
6
Password: password or pin to authenticate to the Wi-Fi network
Go to the bottom of the page and click on the "Save Configuration" button
Go to Step 7.
If the connection is via ethernet port GbE0
Low Voltage Devices | 6-4
– Open network
WPA2-PSK
WPA2-Enterprise
WEP
None
PEAP-MSCHAPV2
PSK
PEAP
TTLS-MSCHAPV2
Figure 6.6: Wi-Fi network internet configuration
Figure 6.7: "Save Configuration" button
(Figure 6.1) e avance ao Step 17.
Figure 6.6:
(Figure 6.7).