Monitoring - WEG Drive Scan Manual

Low voltage devices
Hide thumbs Also See for Drive Scan:
Table of Contents

Advertisement

CONNECTING A DEVICE TO THE DRIVE SCAN
Slave TCP 10
Ethernet network
Modbus-TCP protocol
Modbus TCP
Slave RTU 10
RS-485 network
Modbus-RTU protocol
5
WARNING!
The Drive Scan can only be connected to the internet using the Ethernet port GbE0 if it does not
have a proxy.

5.6.4 MONITORING

The Drive Scan continuously monitors the SSW900 parameters specified in
Cyclically Monitored by the SSW900 on page 5-23
After a cycle of all these readings, as well as of the other assets connected to the Drive Scan, a new reading cycle
starts automatically.
The parameters read are transformed into attributes, which can be:
Only at initialization;
Last value read;
Average value;
Minimum value;
Maximum value.
Every 5 minutes, the Drive Scan publishes the attributes to the WEG Fleet Management platform.
In case of an internet connection failure, the Drive Scan stores the data for up to 30 days in the internal memory,
publishing it to the MFM when the connection is reestablished.
Low Voltage Devices | 5-22
Slave TCP 1
Modbus TCP
Slave RTU 2
Slave RTU 1
Figure 5.9: Possible connections to the SSW900
.
Master
CLP
Drive Scan
Cloud
Section 5.6.4.1 5.6.4.1 Attributes
Motion Fleet Mangement

Advertisement

Table of Contents
loading

This manual is also suitable for:

Drive specialist

Table of Contents