Possible Forms Of Connections; Monitoring - WEG Drive Scan Manual

Parameter
P766
P767
P768
P769
P756

5.7.2 POSSIBLE FORMS OF CONNECTIONS

Figure 5.10 llustrates the possible ways to connect the SRW01 to the Drive Scan.
Slave 20
Ethernet network
Modbus-TCP protocol
SRW01 - Modbus TCP
WARNING!
The Drive Scan can only be connected to the internet using the Ethernet port GbE0 if it does not
have a proxy.

5.7.3 MONITORING

The Drive Scan continuously monitors the SRW01 parameters specified in
Monitored by the SRW01 on page 5-26
After a cycle of all these readings, as well as of the other assets connected to the Drive Scan, a new reading cycle
starts automatically.
The parameters read are transformed into attributes, which can be:
Only at initialization;
Last value read;
Average value;
Minimum value;
Maximum value.
Every 5 minutes, the Drive Scan publishes the attributes to the WEG Motion Fleet Management platform.
In case of an internet connection failure, the Drive Scan stores the data for up to 30 days in the internal memory,
publishing it to the MFM when the connection is reestablished.
Table 5.20: Parameters related to the SRW01 Ethernet Modbus protocol
Description
Gateway 1 0... 255
Gateway 2 0... 255
Gateway 3 0... 255
Gateway 4 0... 255
Modbus TCP 0 a 999,9s
timeout
Slave 2 Slave 1
SRW01 - Ethernet/IP SRW01 - ProfinetIO
Figure 5.10: Possible connections to the SRW01
.
CONNECTING A DEVICE TO THE DRIVE SCAN
Values range
Master
CLP
Drive Scan
Section 5.7.3.1 Attributes Cyclically
Low Voltage Devices | 5-25
Motion Fleet Mangement
Cloud
5