Troubleshooting - Vessel 20USB-S1F Instruction Manual And Safety Instructions

TROUBLESHOOTING

Problem
No rotation
The power tool stops
working during
operation
Abnormal noise
Heat generation
of power tool
Bits cannot be
inserted
Idling of the chuck
Working LED
does not light up
Can't charge
Slow speed
When charging
is complete, the
green light and
the red light are
turned on
alternately.
Possible causes
Battery is not sufficiently charged
Breakdown of the switch, motor or circuit
board
Breakdown of internal parts
Battery is not sufficiently charged
The power tool stops working due to protection
circuit activation.
Breakdown of motor and gear
Temperature increase due to overload
Breakdown of motor and circuit board
Temperature increase due to charging in progress
The bits do not fit
Breakdown of internal parts
Breakdown of internal parts
Breakdown of internal parts
Charger problem
Battery is not sufficiently charged
Breakdown of internal parts
Product specification
Breakdown of internal parts
Solution
Charge battery.
Contact the distributor where you
made the purchase.
Contact the distributor where you
made the purchase.
Charge battery.
Increase the pause time.
Contact the distributor where you
made the purchase.
Increase the pause time.
Contact the distributor where you made the
purchase.
Increase the charging pause time.
Contact the distributor where you made the
purchase.
Contact the distributor where you made the
purchase.
Contact the distributor where you made the
purchase.
Contact the distributor where you made the
purchase.
Confirm whether the output of the connected
charger is 5V DC 1A
Charge battery.
Contact the distributor where you made the
purchase.
Since it is a charging voltage control loop, it has no
operating problem, so it can be used directly.
If the battery still does not rotate after charging or
the battery is not good, contact the distributor
where you made the purchase.
9