Table of Contents
Advertisement
Available languages
Available languages
SIZE
Φ45
140
CHARGING
Use a charger with the specified charging capacity.
(Output: 5 V DC-1 Amp)
If the current value is high, the life of the internal battery will be
shortened.
* This product does not come with a charger.
1) Open the protective cap (see the
figure on the right) of the power
tool charging port and insert the
USB chargingcable.Charging may
not be possible if the USB charging
cable is not correctly inserted into the
charging port.
- Open after pulling out the cap.
- Use the USB charging cable included with this product.
- Opening from the reverse direction will cause a damage.
LED indication
lights up in red while charging.
lights up green when complete.
2) Insert the other end of the USB charging cable to
aUSB port designated in the specifications (com-
mercially available AC adapters, PCs, mobile
batteries, etc.). The charging lamp lights up and the
charging starts. While charging the battery, the charging
lamp lights red. When charging is complete, the charging
lamp lights green.
Note:
The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using the product for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery. The Lithium-Ion battery is
protected against deep discharging.
Note: If the charge level of the battery is less than 15%, the
battery charge lamp will flash red during operation. When
the battery voltage drops to the specified value, it cannot
operate to protect the product. Stop work and charge the
battery.
Φ16
Charging port
(MicroUSB-typeB)
Charging port (USB-typeA)
Note: The product cannot be used during charging. The screw-
driver will not operate if the switch is sliding during charging
- this is not a breakdown.
Note: If not used for a long time, disconnect the charger from
main power.
3) When charging is complete, remove the USB charging
cable and close the protective cap. Dirt and foreign matter
may cause malfunction.
CHANGING THE TOOL
Only use the specified bits. If you use bits other than those
specified, bits may not be possible to be removed.
- Bits that can be used are limited to products with the follow-
ing mounting dimensions.
9.5mm(3/8inch)
- Inserting bit: Slide the sleeve forward, insert the bit all the
way in, and release the sleeve. Move the bit back and forth to
make sure it is locked. Risk of injury if the bit comes off while
operating.
- Removing bit: Slide the sleeve forward, pull out the bit and
release the sleeve. Be careful not to drop bits or the power
tool when operating at height.
CAUTION: Do not slide the switch when inserting
or removing bits. The power tool may operate and cause
injury.
NORMAL ROTATION/
REVERSE ROTATION SWITCH
CAUTION: Do not keep pressing the switch after
the power tool turns off automatically. Internal parts
may be damaged.
The sliding direction of the switch on this product allows it to
rotate in the desired rotation.
- CW: To rotate the spindle clockwise, slide the switch forward
to rotate it, and the LED light will turn on at the same time.
When you release your hand from the switch, the switch
returns to the neutral position and rotation stops, but the
LED light will turn off after 5 seconds.
- CCW: To rotate the spindle counterclockwise, slide the switch
backward to rotate it, and the LED light will be turned on at
the same time. When you release your hand from the switch,
the switch returns to the neutral position and rotation stops,
but the LED light will turn off after 5 seconds.
7
9 mm(0.354inch)
Advertisement
Table of Contents
