Head Restraint Adjustment - Subaru Legacy Outback 2006 Owner's Manual

To adjust the seat height, pull up or push
down the rear end of the control switch.
Reclining the seatback
To adjust the angle of the seatback, move
the control switch forward or backward.

Head restraint adjustment

To raise the head restraint, pull it up.
100250
To lower it, push the head restraint down
while pressing the release button on the
top of the seatback.
The head restraint should be adjusted so
that the center of the head restraint is clos-
est to the top of the occupant's ears.
Never drive the vehicle with the
head restraints removed because
they are designed to reduce the risk
of serious neck injury in the event
that the vehicle is struck from the
rear.
Seat, seatbelt and SRS airbags
NOTE (OUTBACK models only)
If the seatback is reclined rearward to
the same level as the rear seat cushion
with the head restraint removed, a wide
flat bed is made available.
200282
1. Slide the front seat forward as far as
possible.
2. Pull off the head restraint while press-
ing the release button.
3. Recline the seatback rearward up to
the lowest position. Remember to reinstall
the head restraint whenever the seatback
is raised back.
1-5
100251
– CONTINUED –