Spectris Particle Measuring Systems IsoAir 310P Operation Manual page 77

Appendix C Wi-Fi Configuration
The SSID is the name used to connect to the wireless accesspoint and should
be provided by the local IT department.
The WLAN Security Type and Key should be provided by the local IT
department to allow access to the above SSID.
e. All other definitions on the Wi-Fi Bridge web page must remain as shown in
Figure C-5 on page C-7.
f. Click Commit button in the Wi-Fi Bridge web page.
g. If operating outside of the United States, go to the
Wi-Fi bridge and select the region where you are operating.
h. When all the parameters are set, re-boot the Wi-Fi bridge so the changes will
take effect.
5 Re-attach the RJ-45 connector from the Wi-Fi bridge to the sensor's Ethernet
connector.
6 Verify that the sensor can communicate wirelessly.
Page C-8
Instructions for IsoAir 310P Configuration
WLAN Settings
IsoAir 310P Aerosol Particle Sensor Operations Manual
page on the