Figure C-3 Isoair 310P Status Command With Wi-Fi On - Spectris Particle Measuring Systems IsoAir 310P Operation Manual

Instructions for IsoAir 310P Configuration

Figure C-3 IsoAir 310P Status Command with Wi-Fi On

IsoAir 310P Aerosol Particle Sensor Operations Manual
>
?
>sta
IsoAir_310P version:1.02X
Built: Jan 31 2011
MAC Address: 00:60:A6:FF:01:D6
**********Current IP Parameters*************
IP Address: 010.254.000.030
Multicast Address: 224.100.100.001
Net Mask: n/a - WiFi Mode
Gateway: n/a - WiFi Mode
NTP Address: 000.000.000.000
**********After Write IP Parameters*********
IP Address: 010.254.000.055
Multicast Address: 224.100.100.001
Net Mask: n/a - WiFi Mode
Gateway: n/a - WiFi Mode
NTP Address: 000.000.000.000
********************************************
Thresholds: 771 5163 19872 1321
Sample Intervals 60, 60
Tare Interval 0
Repeat Count 0
Analog Input parameters:
Analog 1: Scale: 1.0000 Offset 0.0000
Analog 2: Scale: 1.0000 Offset 0.0000
Analog 3: Scale: 1.0000 Offset 0.0000
Digital Outputs internal (0-4): 10000
When not connected, the led flashes green.
Data Queue set at: 480.
Ethernet Connection via PMS Protocol
Connected to: 010:254:000:102
Aux Board: Analog input detected
Serial Num: 214
Calibrated: 11/23/2010
Auto start disabled
State: Sampling
*********WiFi Default IP Parameters*********
WiFi internal settings enabled.
IP Address: 192.168.002.100
Net Mask: 255.255.255.000
Gateway: 192.168.002.001
********************************************
>
Appendix C Wi-Fi Configuration
Page C-5